Optical Transceiver SFP+ 10.3125Gb/s 1~5m

Product Specification Sheet

OLCSOO1XN-CNMxx

RoHS Compliant 10Gb/s SFP+ Direct Attach Active Copper Cables ,1~5m Reach

PRODUCT FEATURES

●Support for multi-gigabit data rates up to

10.5Gbps

●Data rates backward compatible to 1Gbps

●Hot-pluggable SFP 20PIN footprint ● Available in lengths of 1, 1.5, 2, 2.5, 3, 5m ●Metal with lower EMI ●Compliant with SFF-8472 Rev 11.1 ●Compliant with SFP+ MSA: SFF-8431 Rev4.1

●Low Power Consumption < 0.5W

●Power Supply :+3.3V

●Compatible to SFP+ MSA

●Temperature Range: 0~ 70 °C

APPLICATIONS

●High capacity I/O in Storage Area Networks, Network Attached Storage, and Storage Servers

●Switched fabric I/O such as ultra high bandwidth switches and routers

●Data center cabling infrastructure

●High density connections between networking equipment

STANDARD

●ESD to the Electrical PINs: compatible with MIL-STD-883E Method 3015.7

●RF Immunity compatible with IEC 61000-4-3

●EMI compatible with FCC Part 15 Class B EN55022 Class B

●RoHS compliant with 2002/95/EC 4.1&4.2 2005/747/EC

PRODUCT DESCRIPTIONS

The SFP+ cable assemblies are high-performance, cost effective I/O solutions for 10Gb Ethernet and 10G Fibre Channel applications. SFP+ copper modules allow hardware manufacturers to achieve high port density, configurability and utilization at a very low cost and to reduce power budget. The high-speed cable assemblies meet and exceed the performance and reliability requirements stipulated by Gigabit Ethernet and Fibre Channel industry standard.

ABSOLUTE MAXIMUM RATINGS

Note: Stress in excess of the maximum absolute ratings can cause permanent damage to the module

GERERAL OPERATING CHARACTERISTICS

Pin Definitions and Functions

Note 1) The module ground pins shall be isolated from the module case.

Note 2) This pin is an open collector/drain output pin and shall be pulled up with 4.7K-10Kohms to Host_Vcc on the host board.

Note 3) This pin shall be pulled up with 4.7K-10Kohms to VccT in the module.

Note 4) This pin is an open collector/drain output pin and shall be pulled up with 4.7K-10Kohms to Host_Vcc on the host board. In FC designated as RX_LOS, inSONET designated as LOS, and in Ethernet designated at Signal Detect.

PACKAGE DIMENSIONS

Ordering Information